Internal Sauna Vents

Rectangular Internal vents

A rectangular wall vent for the interior of sauna. Slides horizontally to open or close. Red Cedar or Yellow Cedar. Approximately 33cm x 13cm.

Circular internal vent

A useful little air vent, for the home sauna builder.

The wooden cover measures 140mm across with 100mm internal diameter/flange to allow air flow. Opens and closes by spinning the outer wooden cover.

Applies to Circular and Rectangular. If used for exhaust circulation they are normally open/partially open when the sauna is in use (used in conjunction with an open input vent near the heater).

If used for drying the room, these are classically used in a closed position, when the sauna is in use and opened fully afterwards; to help the room to dry out.

This vent is usually located very high up in the room or set into the ceiling as a drying vent or at the height your heater manufacturer recommends for the exhaust circulation vent.

European made, this unit consists of a circular spruce cover, thread and a metal attachment piece with flange. Could be stained with a health based low VOC oil to match the interior paneling colour.

Beech square vent

A nice little European made timber vent grille for the home sauna builder.

Measuring 140mm x 130mm on the face with a rectangular 120mm x 105mm insert on the rear. The grille is 15mm thick and made in Germany from European Beech.

Please note that this is not an adjustable vent and is handy for covering up a visible internal input vent hole or an exhaust vent hole that is on the inside of a building and requires a stylish solution.